 |
 |
 |
 |
|
- Plain Weave
Fabric Shall be formed by spacing the
main and cross wires at a right angle.
When all the main and cross wires are
parallel and equally intervals, the mesh
forms a square,and,when the width is different,it
becomes rectangular.
Meanwhile,production of plain weave up
to the same wire gauge as open mesh is
theoretically possible. But use of wire
gauge about 80% of open mesh is optimum
due to changes in structure at the time
of weaving.
- Twilled
Weave
Contrary to plain weave,two lines of the
main and cross wires are interweaved alternately.
It is possible to use a wire thicker then
the mesh of twilled weave and,it ha an
advantage of vulcanization being small
because the angle of refraction of the
main and cross wires is big. It is suitable
for cases of comparatively high or much
load.
- Plain Dutch
Weave
As a derivation of plain weave,the mesh
of main wires is broad,and the cross wires
are stricked together closely,letting
liquids or air
pass through the intersections of the
main and cross wire. This net is best
suited for filtering dehydration,and separation
of centrifugal separatores. Mesh is indicated
by the number of weft wires between a
distance of 25.4mm.
- Twilled
Dutch Weave
The process of manufacture of twilled
dutch weave is a combination of twilled
weave and dutch weave. The cross wires
are sticked fast to both the interior
and exterior of the net.
This has a density twice that of dutch
weave,being the most minute and firm filtrator
for separation. It is possible by the
number of weft wires between a distance
of 25.4mm.
|
 |
 |
 |
 |
|
|
| |
|
|
|
